How do you apply your Safecoat DuroStain on larger projects? Successful completion of a large project often requires 2 or 3 people. Keep the working environment cool with moderate ventilation. Following the instructions should make the job go much easier. 1. Test the surface for porosity evenness by sprinkling water over the wood. If you detect uneven penetration, a coat of Lock-in sanding sealer will be necessary to even up the differences. Allow Lock-in to dry for 1 hour and then lightly sand. 2. Damp sponge the entire working surface with water. While the surface is damp liberally apply the Durostain with the grain using a good quality, wide bristle brush. Another method is to use a squeegee to spread the stain. Remember to work at a brisk pace keeping a wet edge. Have a spray bottle of water nearby to keep the unstained surface moist. 3 .Allow the stain to penetrate for ten seconds. Working with the grain, have your assistants wipe off the excess with clean rags as you continue applying the stain. In you will want to terminate a pass with the stain at a logical finishing point like the end of a plank or board. Work in a string pattern moving from one side of the room to the other until complete. Allow 24 hours to dry before applying a Safecoat clear protective sealer.
|
DUROSTAIN NO VOC WOOD STAINS 250 square ft a gallon-brush on and wipe off
|
